[WizzyWigg]

@x10sjr This link might help
https://www.equiwatt.com/help/where-...me-display-ihd

[geoffers]

Originally Posted by x10sjr

@geoffers I downloaded the app. I have a SMETS 2 meter but cannot find the GUID for it.

The meter itself has an identifying MPAN number (meter point administration number) which you can find on your bill, or by scrolling through the displays on the meter
https://www.comparethemarket.com/ene...t/mpan-number/

You will also need your IHD's GUID which you can view on the IHD by scrolling through its settings menus or as @retrotecchie says it's printed on the back/bottom of the IHD itself

[DebF_EONNext]

Hey @Gunnie47 👋

I'm going to pop you a DM and see if there's anything more I can do to chase this up for you 😊

[EV7]

Does the Bright app display the day and night meter readings plus gas and read all 3 every half hour?

[geoffers]

Originally Posted by EV7

Does the Bright app display the day and night meter readings plus gas and read all 3 every half hour?

Yes 👍- your meter probably only stores one of the tariff rates, so by default Bright will only pick this value up from the meter, but you can override this and enter your actual tariff rates to get the correct costings.

Also you can download your ½ hourly usage in CSV format from their website at glowmarkt.com and load this into a spreadsheet etc

[EV7]

That screen shot is based on time though.
Night rate tariff 12p can be the same for 24 hours it's just that the meter only increases during the night period it's set to say 00:30 to 07:30.
Same for day tariff 26p - can be the same for 24hours it's just that the meter only counts it during the day outside 00:30 to 07:30

Does the App display the meter reading for day and the meter reading for night every half hour?
eg
6am day 1234 night 5678
7 am day 1234 night 5685
8am day 1240 night 5690
9am day 1245 night 5690
Obviously the day reading wont increase over night and the night reading wont increase during the day.

[geoffers]

@EV7 Yes it does - the meters record half hourly energy usage which is picked up by Bright: the tariff rate is then applied for costing based on TOU

You can view the display in kWh or cost (these are the cost displays)

[retrotecchie]

@geoffers

Looking at your screenshot, I'm assuming that SC figure is for both utilities? Either that or you live in one of the only two regions more expensive than South Wales 🤣🤣

I'm paying 52p a day SC for 'leccy only and that's daylight robbery 😜

[EV7]

Thanks - is TOU Time of Use?
For an Eco7 meter you just need the meter reading day x tariff day plus meter reading night x tariff night.
Using time is probably for a single rate meter where time is used for the changeover point.
It give different total to the meter readings

All I'm hoping the half hour readings to do is let me know both actual meter readings at that point.
Can the App display both readings?

[geoffers]

Originally Posted by retrotecchie

@geoffers Looking at your screenshot, I'm assuming that SC figure is for both utilities? Either that or you live in one of the only two regions more expensive than South Wales

Ahhh - but I bet you don't get 7 hours worth of electricity at 6.7p/kWh hour 😉