Gas meter SMETsV2 - no meter reading 18days but getting half hourly usage

  • Thewookiewon's Avatar
    Level 8
    Hello,

    My gas meter is set to half hourly and I can see the usage fine in the app but when I check in the meter read section it says nothing seen for 18 days.

    My electric is also half hourly, usage fine and meter read says "you don't need to subnet readings as we're getting them half hourly".

    Shouldn't the gas section be stating the same thing on half hourly? Screenshots attached
    Attached Images Attached Images   
  • 13 Replies

  • Mailman's Avatar
    Level 60
    @Thewookiewon

    The usage per 30 min is not the same as the Meter read. Put it another way, if you were to add up all the 30 min usage data over the whole day you would end up with the same usage derived by taking the difference between the Meter reads at 0000 and 2359 and using the conversion formula to convert say m3 into kWh. The smart meter read will only be pulled once a month unless your bill covers a cap changeover date. What you see with your account is what I see with mine.

    I shall check my app in the morning as my online account is not confusing. Perhaps the app is open to misinterpretation for the reasons stated in your post but will check and get back to you unless someone else can confirm.
    Last edited by Mailman; 18-07-24 at 23:06.
  • Thewookiewon's Avatar
    Level 8
    @Thewookiewon

    The usage per 30 min is not the same as the Meter read. Put it another way, if you were to add up all the 30 min usage data over the whole day you would end up with the same usage derived by taking the difference between the Meter reads at 0000 and 2359 and using the conversion formula to convert say m3 into kWh. The smart meter read will only be pulled once a month unless your bill covers a cap changeover date. What you see with your account is what I see with mine.

    I shall check my app in the morning as my online account is not confusing. Perhaps the app is open to misinterpretation for the reasons stated in your post but will check and get back to you unless someone else can confirm.

    I completely get that, but I do belive the gas meter reading area should reflect the same message as the electric meter then.

    "you don't need to submit meter readings, we receive your gas usage automatically from you smart meter half hourly"
    Last edited by Thewookiewon; 19-07-24 at 07:25.
  • Mailman's Avatar
    Level 60
    @Thewookiewon

    Checked with my app - as I am not on a TOU (Time of Use) electricity tariff my last meter reads were both taken on 1st July and both utilities state 'It's 18 days since your last reading'. perhaps you are on a TOU and have to have the electricity reads pulled much more often. 👍
  • geoffers's Avatar
    Level 37
    I completely get that, but I do belive the gas meter reading area should reflect the same message as the electric meter then.

    "you don't need to submit meter readings, we receive your gas usage automatically from you smart meter half hourly"
    Don't see why you would expect this - I'm on TOU for electricity EV tariff so the meter reading section for electricity says
    You don't need to submit meter readings, we receive your electricity usage automatically from your smart meter every half an hour.

    However the gas isn't billed on a TOU basis so they're only interested in the monthly cumulative readings, so the meter reading section says
    Enter your meter reading

    You can ignore the numbers after the decimal place and any numbers in red.

    Enter your reading

    last actual reading: 2458.623 on 21/06/24

    This is actually irrelevant as they pick up your readings directly from your meter, so you never really need to go to this page on the account/website
    Last edited by geoffers; 19-07-24 at 14:28.
  • Thewookiewon's Avatar
    Level 8
    Don't see why you would expect this - I'm on TOU for electricity EV tariff so the meter reading section for electricity says

    However the gas isn't billed on a TOU basis so they're only interested in the monthly cumulative readings, so the meter reading section says

    1. Your tone isn't appreciated, I'm providing feedback based on experience from other suppliers.

    2. Because the gas is set to half hourly readings same as the electric. The UI should represent the same information, I shouldn't need to provide a read if half hourly is selected on both meters.

    3. My previous supplier only billed my gas on a static cost per unit set to half hourly, they blocked out the ability to submit meter readings as no point when set to half hourly. They also showed the daily reading in the same area so I had visibility of the actual reading captured.
  • geoffers's Avatar
    Level 37
    1. Your tone isn't appreciated, I'm providing feedback based on experience from other suppliers.
    I don't see why my "tone" has anything to do with it - I'm just trying to be helpful in explaining my experience with this supplier, and other suppliers probably do things differently (and none of them are perfect ☹️)
  • WizzyWigg's Avatar
    Level 88
    Never found any app that gives you exactly what you would like or want.
    With respect to energy usage, first principles are best. Eyes, brain, and the nearest thing to modern life, a spreadsheet. Way simpler, faster, more accurate, and gives precisely what you want, when you want it.👴
  • meldrewreborn's Avatar
    Level 91
    @Thewookiewon

    suppliers do not use any regularly submitted readings visible in an app for billing purposes. They send a request to the meter once a month and ideally get a response back.

    only if the automated process fails ( not an uncommon experience) is it necessary to submit a manual reading via the online account - assuming you wish to keep your account on track.
    Current Eon Next customer, ex EDF, Zog and Symbio. Don't think dual fuel saves money and don't like smart meters. Chronologically Gifted. If I offend let me know by private message, but I’ll continue to express my opinions nonetheless.
  • Thewookiewon's Avatar
    Level 8
    Well my previous supplier did it that way, it was more modern, simple and easy to understand.

    If both meters are connected and set to half hourly then there is no point showing me excess UI to submit a reading.

    With the other provider for Electric import, electric export and gas meters, I could select either meter and had 2 tabs (usage and reading), these displayed the exact usage in kWh or m3 against each day of the month or the actual meter reading captured for that day.

    If Eon Next are trying to modernise their approach that's what their competitors are doing.